Rebuild Info - Pic Request
Posted: Tue Apr 12, 2011 5:44 pm
Gents as you know, just before Xmas on my return from Saudi I fell off the road as I didn't change my tyres over...
Thankfully this only meant a cracked front bumper and a slightly bent lower X member.
I have taken advantage of this and fitted a new radiator, new cooling matrix - along with an AC recharge, sprayed up and protected the bumper X member as well as the lower X member. Plus got my bonnet re-sprayed again too!!
I am now in the process of putting it all back together again, with all new fixings and plastic clips...but I have a slight request for you guys.
So far I have put back everything bar the front bumper, winglets and headlights. BUT - putting my old bumper back on for a test fit, there is 3 fixing holes in the middle of the lower lip..I can't seem to see where this attaches..and there isn't any marks to indicate they were used at all.
Can somebody just grab a pic of the underside of their bumper (obviously those with a splitter are pardoned) so I can see if they are used - and if I am missing any part.
The workshop manual says they are used, but don't give much detail into the drawings so I can see how!!
Thanks people!!
Thankfully this only meant a cracked front bumper and a slightly bent lower X member.
I have taken advantage of this and fitted a new radiator, new cooling matrix - along with an AC recharge, sprayed up and protected the bumper X member as well as the lower X member. Plus got my bonnet re-sprayed again too!!
I am now in the process of putting it all back together again, with all new fixings and plastic clips...but I have a slight request for you guys.
So far I have put back everything bar the front bumper, winglets and headlights. BUT - putting my old bumper back on for a test fit, there is 3 fixing holes in the middle of the lower lip..I can't seem to see where this attaches..and there isn't any marks to indicate they were used at all.
Can somebody just grab a pic of the underside of their bumper (obviously those with a splitter are pardoned) so I can see if they are used - and if I am missing any part.
The workshop manual says they are used, but don't give much detail into the drawings so I can see how!!
Thanks people!!