Users browsing this forum: No registered users and 16 guests
| |||||
Moderators: WR 1mposter, The Swede, Megaman, danr55, WR1 Bro
centre section exhaust de-catis it worth getting one or have they already been removed as not had chance to have a look yet
No center cat
The up-pipe is catless aswell The only cat is the Prodrive downpipe which some say is just as good as a de-cat 2007 BMW M5
2004 Petter Solberg STi
Agreed but de-catting the down pipe d0es increase the "burble" quite substantially Crash bang wollop!!
...and also adds boost creep, unless you port the turbo wastegate.
Anders Engine: FMIC with K&N CAIK, Oil Catch Can & MD321H turbo. Next mod: TBD
Brakes: Turbo Groove Discs, Pagid RS29's & Braided Hoses. Suspension: Whiteline front and rear ARB's, ALK
Probably... If your getting a de-cat go for a remap as well @ Crash bang wollop!!
There is not a cat in the centre as o.e...you can't get much higher flow than that.
You can get replacement stainless centres though.
i was just going by the fact it has a very small silencer on it that was all suppose straight through centre section would make it just a tad louder then
I fitted a non-resonated centre section and it got a bit louder. It lets a few more pops and bangs through, but not as much as a full decat would. The cabin noise is fine too Anders Engine: FMIC with K&N CAIK, Oil Catch Can & MD321H turbo. Next mod: TBD
Brakes: Turbo Groove Discs, Pagid RS29's & Braided Hoses. Suspension: Whiteline front and rear ARB's, ALK
HAYWARD AND SCOTT - Will supply Stainless zorsts with lifetime gaurantee at a fraction of teh cost of dealers - they manufacture for quite a few.
they are based in Essex and if you call them they will usually change components feww of chareg and also arrange for the cel fix to be done for around Crash bang wollop!!
[quote="Spike "THE LEGEND" Mike XXX"]HAYWARD AND SCOTT - Will supply Stainless zorsts with lifetime gaurantee at a fraction of teh cost of dealers - they manufacture for quite a few.
they are based in Essex and if you call them they will usually change components feww of chareg and also arrange for the cel fix to be done for around 2007 BMW M5
2004 Petter Solberg STi
[quote="WR 1mpostor (aka number 1 moderator)"][quote="Spike "THE LEGEND" Mike XXX"]HAYWARD AND SCOTT - Will supply Stainless zorsts with lifetime gaurantee at a fraction of teh cost of dealers - they manufacture for quite a few.
they are based in Essex and if you call them they will usually change components feww of chareg and also arrange for the cel fix to be done for around Crash bang wollop!!
I bought mine second hand on ScoobyNet for Engine: FMIC with K&N CAIK, Oil Catch Can & MD321H turbo. Next mod: TBD
Brakes: Turbo Groove Discs, Pagid RS29's & Braided Hoses. Suspension: Whiteline front and rear ARB's, ALK
| ||
Who is onlineUsers browsing this forum: No registered users and 16 guests |
||