Users browsing this forum: No registered users and 5 guests
| |||||
Moderators: WR 1mposter, The Swede, Megaman, danr55, WR1 Bro
Front splitter?Hi there looking for some info on a front splitter for my wr1.
where and what would be the best kind to get? thanks
Heres a photo of mine;
(photo removed, sorry) and heres where I had it from. Dead easy to fit and great quality. If you make them an offer of £100 they should accept; http://cgi.ebay.co.uk/Subaru-Impreza-ST ... dZViewItem Last edited by MY498 on Sat May 17, 2008 6:39 pm, edited 1 time in total.
Yeah, the HT Auto's splitter is very good quality. I have one on mine, too.
2004 RB Renault Clio 182 (Coilovers running Mark Fish setup)
Hi,
I have a scott lowe fibre glass splitter on mine and have also fitted the one that has been recommended above on Zimmerman's car. They are equally easy to fit, however I think that the plastic one is more likely to survive a parking incident..... Sadly I have found out to my cost that the fibre glass one doesn't. Still, repaired and repainted and back on the car now. Ex 05 Sti PPP Type UK
300 BHP, 298 FtLb Now Vw Scirocco GT 140 BHP
HT Autos one on mine too, took 15 mins to fit and makes such a difference to the front end
Going round corners just got a whole lot faster...
Looks like you parked too close to a high kerb.
Ouch - hope it is repairable. Duncan : www.racedynamix.com
email: duncan@racedynamix.com tel: 07540 185754 Custom Remaps for: All Impreza/Forester 2001-2010 | Classics 92-96 (ESL) | Syvecs (Solaris) | Simtek
well the mrs thats wot happend apparantely a dead deer jumped under my car
well i have got the splitter off and have got it at work i think i can do somthing with it fingers crossed
Stick it up the mrs's arris thats what Still have mine in the garage in 2 bits, i may try and repair it for Spa again, they tell me the grass has'nt been cut in 2 years 2007 BMW M5
2004 Petter Solberg STi
Hi.. got the sti front splitter on mine..expensive but great quality..was out the other night having some fun came round a long bend at speed, only to see a just laid table top speed bump.. thought about braking but the front would have dipped..so floored it instead splitter hit the speed bump..did not fall of or crack..just a little scrape on the underneath...but you need to plan your route with a splitter though..most car parks are a no go etc.
________ Drug Test Kit Last edited by stanley on Sat Feb 19, 2011 5:21 am, edited 1 time in total.
well after months of trying to decide whether to get a splitter finally received it today from ht autos but not that impressed by the finish on it,don't want to spray it blue as think it looks cool in black,but not sure whether to spray it black to give a better finish?has anyone else done this?
kev, do you think you could post some pictures? I am thinking of getting an HT Auto one also but not if the finish is low quality.
as above was thinking of getting it myself would not mind a few pictures.
Gracing the drive.....BMW M3 E92 with all the toys!/Integra DC5/ Integra DC2 race car/BMW X5
gone...Impreza RB320 No 112 gone...Impreza WR1 No 84 gone...Civic Type R EP3 gone...Seat Leon Cupra 225 gone...Civic Type R EP3 gone...(shed with weels)
Kev - put something like Meguiars All Season Dressing on it. This darkens it up no end and doesnt make that "ready to paint" look so obvious. I do it with mine and i'm happy enough with it staying black
Going round corners just got a whole lot faster...
Thats the splitter finally on got very wet in the process but was worth it
i am quite very with it now that its on,after cleaning it up looks alot better.when it arrived it had some kind of glue or something on it but it came of fine.I will try and post some pics asap. next on the list de tango the headlights any advice on doing this if you have done it would be much appreciated.
yeah, dont get your fingers trapped between the case and lense cos it hurts like f*ck
Going round corners just got a whole lot faster...
| ||
Who is onlineUsers browsing this forum: No registered users and 5 guests |
||